1. Product Overview
The sand temperature regulator uses circulating water to cool or heat the sand material by ensuring full contact between the sand particles and the pipes inside the cooler, allowing for heat exchange to complete the cooling or heating task.
2. Components
The sand temperature regulator consists of several cooling sections, equipped with flow regulation plates and manual shut-off plates. Each cooling section contains multiple drainage pipes. The sand, after being air-classified, flows evenly through these cooling pipes, allowing it to cool down. The flow regulation plate consists of two layers of perforated plates, and the sand flow is controlled by adjusting the misalignment of the plates. The entire system uses automated control and is equipped with temperature sensors. After cooling, the sand temperature is fed back to the control center via the sensors for intermittent discharge.
3. Parameters
Production rate: ≥20~40T/h
Circulating water volume: 40~100 m³/h
Water pressure: 0.2-0.4Mpa
Cooling steel pipe: φ25×3
4. Main Functions and Advantages
Main Functions:
Reduce sand temperature to ensure molding quality
Stabilize production rhythm and improve efficiency
Pre-mix sand and homogenize temperature
Core Advantages:
Improve casting quality
Increase production efficiency
Heat energy recovery and environmental protection
Controllable automation
Stable and reliable operation
Product Tags:
|
|
Sand Temperature Regulator with Manual Shut Off Plates and Circulating Water Systems for Production Rate ≥20~40T/h Images
|
